Coleman Spas Hot Tub Error Codes
Lay Z Spa pump Troubleshooting with error codes E01: Unplug the pump. With one hand hold the pump and with the other hit the pump three times strong enough to shake the internal components. Plug in the pump, if the control panel still displays the alarm E01, please contact your local Bestway Aftersales Service to get instructions.
Coleman Spas Hot Tub Jets
E02: E02 means that the system doesn’t detect the water flow, Unplug and plug in the pump, and put your hand in front of the upper valve inside of the spa, then, press the Water Filter Button to check if there is any water flow. If no water flows from the upper valve: Check if the stopper caps were removed from the inlet/outlet pipe. Check if the filter cartridges are dirty. Check if there are any blockages in the pipes. If after above operation the pump displays E02, please contact your local Bestway Aftersales Service point for instructions.
Tere Bina - Female MP3 Song by Shreya Ghoshal from the movie Tezz. Download Tere Bina - Female song on Gaana.com and listen offline. Tere bina zindagi. Mix - Tere Bina(Female Version) By Shreya.Raj Collection.!YouTube. Tera Mera Pyar - Kumar Sanu.
Hot Tub Error Code List
If water flows from the inlet pipe: Please contact your local Bestway Aftersales Service point to get instructions. E03: E03 means that the water temperature is lower than 4ºC Note: DO NOT USE THE SPA if this is displayed. Check the water temperature with a thermometer, If the water temperature is lower than 4ºC, unplug the pump and wait until the water temperature reaches 10°C, then plug in to restart the pump. If the water temperature is over 4ºC, Unplug and plug in, if the pump still displays E03 then the temperature sensor is broken, please contact your local Bestway Aftersales Service point for instructions. E04: E04 means that the water temperature is over 50ºC NOTE: DO NOT USE THE SPA if this is displayed Check the water temperature with a thermometer, If the water temperature is between 40ºC and 50°C or over, unplug the pump and wait until the water temperature reaches 38°C, then press the reset button (see the PUMP OPERATION part in the Owner’s Manual) and then plug in to restart the pump.